Auto Channel Scan - Sylvania LC320SS9 B Manual Del Usuario

[] Main Menu
Thissection describes t heoverviewofthe mainmenudisplayed whenyou
press[SETUP]. F ormoredetails, see thereference pageforeach item.
The mainmenuconsists o f the functionsetting itemsbelow.
Press [SETUP].
EXIT
To exit settings.
PICTURE
You can adjust the picture quality.
(Refer to "Picture Adjustment" on page 22.)
SOUND
You can adjust the sound quality.
(Refer to "Sound Adjustment" on page 23.)
CHANNEL
You can automatically scan the viewable channels and
remove the undesired channels.
(Refer to "Auto Channel Scan" on page 14.)
DETAIL
You can change the display format for closed caption,
which displays the dialogue of a %/program or other
information across the %/screen.
(Refer to "Closed Caption" on page 24.)
You can set the viewing limitations.
(Refer to "V-chip" on page 28.)
You can adjust the position, stability and clarity of the
PC screen.
(Refer to "PC Settings" on page 31 .)
You can select the sound input for the HDMII input
jack if your unit is connected to an HDMI or DVI device.
(Refer to "HDMI Audio" on page 32.)
LANGUAGE
You can change the language (English, Spanish,
French) displayed on the main menu.
(Refer to "Language Selection" on page 15.)
[]Auto Channel Scan
Ify0u switchwires (e.g., between antenna and CATV) o r ify0u movethe
unit to a different areaafter the initial setting, or if you restorethe DTV
channel y ou deleted, you will needto perform auto channel s can.
Before you begin:
Makesureif the unitisconnected to antennaorcables.
Press [SETUP] to display the main menu.
2 Use [Cursor A/V] to select "CHANNEL", then press
[ENTER].
or
3
Use [Cursor A/V] to select "Autoscan", then press
[ENTER].
or
Use [Cursor A/V] to select an appropriate option, then
press [ENTER].
or
• When aerial antenna is connected, select "Air".
• When connected to CA%/, select "Cable".
• Scanning and memorizing of channels start
automatically.
• When the scanning and memorizing are completed,
the lowest memorized channel will be displayed.
EN