Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
[] FAQ
• Check the antenna
or cable connection
to the main unit.
• Check the batteries
of the remote control.
• Check if there is an obstacle between
the infrared sensor window
and
the remote control.
• Test the signal output.
If OK, then possible infrared sensor trouble.
{Refer to"lR Signal Check"on
page 353
• Aim the remote control
directly
at the infrared sensor window
on the
My remote control
does not work. What
front of the unit.
should
I do?
• Reduce the distance to the unit.
• Re-insert the batteries with their polarities
(+/- signs) as indicated.
• When there is an infrared-equipped
device such as PC near this unit, it
may interrupt
the remote control signal of this unit.
• Move the infrared-equipped
device away from this unit, change the
angle of the infrared sensor or turn off the infrared
communication
function.
How come the Initial setup appears every
i Connect the RF Cable to the unit directly
and run the initial setup.
time I turn on this unit?
° Make sure to complete
the channel
scan before turning
off the unit.
• Make sure auto channel
scan has been completed.
{Refer to"Auto
Channel Scan"on
page 143
• Auto channel
scan must be completed
when you set up the unit for the
first time or move it to a location
where previously
unavailable
channels
are broadcast.
• The selected channel
may not be broadcasting.
• When auto channel
scan is interrupted
and not completed,
Why I cannot watch some of TV programs?
some channels will not be received.
Make sure to complete.
(Refer to"Auto
Channel Scan"on
page 14.)
• The selected channel
cannot be viewed
by the V-chip setting.
(Refer to "V-chip" on page 28.)
• The unit requires some kind of antenna
input. An indoor antenna
(rabbit
ears), an external
antenna,
or an RF coaxial cable from your wall or cable
/satellite
box needs to be plugged
into the unit.
• Check if the right input mode is selected
by pressing [INPUT SELECT] 0 i
How come there is no image from the
using [(::H A/V
]. {Refer to"Switching
Each Input Mode'!on
page ! 7.)
connected
external devices?
• Checkthe
antenna
or Cable connection
to the unit.
Whenever
I entered
channel number,
it changes automatically.
Why are captions
not displayed
entirely?
Or, captions
are delayed
behind the
dialogue.
• Many digital
channels
have alternate
channel
numbers. The unit changes
the numbers
automatically
to the ones signifying
the broadcasting
stations. These are the numbers
used for analog broadcasts.
, Captions that are delayed
a few seconds behind the actual dialogue
are
common
for live broadcasts.
Most Captioning
production
Companies
can
display
a dialogue
to maximum
of 220 words per minute.
Ira dialogue
exceeds that rate, selective
editing
is used to insure that the captions
remain up-to date with the currentTV
screen dialogue.
How can I set the clock ?
• There is no clock function
on this unit.
EN
Publicidad
Tabla de contenido
