Cequent 37152 Instrucciones De Instalación página 14

VEHICLE FRAME
USE THIS HOLE
FOR CENTER
SECTION ASSEMBLY
NOTE:
General assembly - loosely assemble center section (page 1); loosely install side brackets on vehicle (this page);
install center section assembly (page 2-3); tighten all fasteners to proper specifications (page 1)
2002-07 JEEP LIBERTY
1. If vehicle is equipped with a fuel tank shield, remove the two rearmost 12mm bolts from each side.
2. Lift the side brackets up to the frame in orientation shown and align hole 1. in side bracket with the
rearmost weldnut. Loosely install the supplied 12mm hex bolts, lock washers, and flat washers
into existing weldnuts in frame.
3. Install center section per SIDE BRACKET LOCATION 3. (See page 3.)
REFER TO SIDE BRACKET LOCATION INSTRUCTIONS FOR PROPER BOLT TIGHTENING SEQUENCE
1/2" FLAT WASHER
1/2" LOCK WASHER
12mm X 1.75 X 40mm
HEX BOLT
HEAT SHIELD
IF PRESENT
INSTALLATION L
TOOLS REQUIRED
19mm SOCKET
TORQUE WRENCH
SAFETY GLASSES
EXISTING
WELDNUTS
HOLE # 3
HOLE # 1
12mm X 1.75 X 40mm
HEX BOLT