GRE HPGI50 Manual De Instrucciones página 70

6.2.3 button
Parameter checking :
Press first, then press
Code
d0
d1
d2
d3
d4
d5
d6
d7
d8
d9
d10
d11
Press first, then press
If needed, press
(for example: Press
press or
Code Name
P0 Manual defrost
P1 Working mode
P2 Timer on/off
P3 Water pump
P4 Current time
P5 Timer on
P6 Timer off
Inlet water temp.
P7
correction
NOTE: Under defrosting mode, P0=1.
After defrosting finished, it will be automatic enter Normal mode, P0=0.
to check the " User parameter from d0 to d11
Condition
IPM mould temperature
Inlet water temp.
Outlet water temp.
Ambient temp.
Frequency limitation code
Piping temp.
Gas exhaust temperature
Step of EEV
Compressor running frequency
Compressor current
Current fan speed
Error code for last time
to check the " User parameter from P0 to P7
second, then press
first, then press
to adjust the parameter P7 Inlet water temp. Correction from -9 to 9.)
Scope Default
0-1 0 1 Manual defrosting mode, 0 Normal mode
1 1 1 Heating mode (Non-adjustable)
1 Timer on/off is under function ， 0 Timer on/off is out of
0-1 0
function (The setting of P5 and P6 won't work)
0-1 0 1 Always running, 0 Depends on the running of compressor
HH:MM 0-23:0-59
00：00
HH:MM 00：00 0-23:0-59
HH:MM 00：00 0-23:0-59
-9～9 0 Default setting: 0
Scope
0-120℃
-9℃～99℃
-9℃～99℃
-30℃～70℃
0,1,2,4,8,16
-30℃～70℃
0℃～C5℃ (125℃)
0～99
0～99Hz
0～30A
0-1200 （rpm）
All error code
or to adjust the current parameter.
to enter parameter P7 checking, and press
Remark
68
Remark
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
Real testing value
N*5
Real testing value
Real testing value
Real testing value
second, then