Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
OPERATION
TO MOVE FORWARD
AND BACKWARD
(See Fig. 7)
The direction and speed of movement is controlled by the
forward and reverse drive pedals.
•
Start tractor and release parking brake.
•
Slowly depress forward (K) or reverse (L) drive pedal to
begin movement. Ground speed increases the further
down the pedal is depressed.
TO USE CRUISE
CONTROL
(J) (See Fig. 7)
The cruise control feature can be used for forward travel only.
Fig. 7
•
The average
lawn should be cut to approximately
2-1/2" during the cool season and to over 3" during hot
months. For healthier and better looking lawns, mow
often and after moderate growth.
•
For best cutting performance, grass over 6" in height
should be mowed twice. Make the first cut relatively
high; the second to desired height.
TO ADJUST
GAUGE WHEELS
(See Fig. 9)
Gauge wheels are properly adjusted when they are slightly
offthe ground when mower is atthe desired cutting height in
operating position. Gauge wheels then keep the deck in prop-
er position to help prevent scalping in most terrain conditions.
NOTE: Adjust gauge wheels with tractor on a flat level
surface.
•
Adjust mower to desired cutting height (See"TOAD JUST
MOWER CUTTING HEIGHT" inthis section of manual).
•
With mower indesired heightofcut position, gaugewheels
shou Id be assembled so they are slightly off the ground.
Install gauge wheel in appropriate hole. Tighten securely.
•
Repeat for all, installing gauge wheel in same adjust-
ment hole.
SYSTEM CHARACTERISTICS
The cruise control should only be used while mowing or
transporting on relatively smooth, straight surfaces. Other
conditions such as trimming at slow speeds may cause the
cruise control to disengage. Do not use the cruise control
on slopes, rough terrian or while trimmimg or turning.
•
With forward drive pedal depressed to desired speed,
pull cruise control lever (J) up and hold while lifting
your foot off the pedal, then release the lever.
To disengage the cruise control, depress the brake pedal
or tap on forward drive pedal.
TO ADJUST
MOWER
CUTTING
HEIGHT
(See Fig. 8)
The position of the attachment lift lever (A) determines the
cutting height.
Fig. 8
Fig. 9
TO OPERATE
MOWER
(See Fig. 10)
Your tractor is equipped with an operator presence sensing
switch. Any attempt by the operator to leave the seat with
the engine running and the attachment clutch engaged will
shut off the engine. You must remain fully and centrally
positioned in the seat to prevent the engine from hesitating
or cutting off when operating your equipment on rough,
rolling terrain or hills.
1.
Select desired height of cut with attachment lift lever.
2.
Start mower blades by engaging attachment clutch.
TO STOP MOWER BLADES -
Disengage attachment clutch control.
•
Put attachment lift lever in desired cutting height slot.
The cutting height range is approximately
1" to 4". The
heights are measured from the ground to the blade tip with
the engine not running. These heights are approximate and
may vary depending upon soil conditions, height of grass
and types of grass being mowed.
10
Publicidad
Tabla de contenido
