Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
SERVICE AND ADJUSTMENTS
_
WARNING: TO AVOID SERIOUS iNJURY, BEFORE PERFORMING ANY SERVICE OR ADJUSTMENTS:
*
Depress brake pedal fully and set parking brake.
*
Place attachment clutch in "DISENGAGED"
position.
*
Turn ignition key to "STOP" and remove key.
*
Make sure the blades and all moving parts have completely stopped.
*
Disc_nnects_ark__ugWirefr_ms_ark_iugandp_acewirewhereitcann_tc_meinc_ntactwithpiug_
TO REMOVE
MOWER
(See Fig. 20)
•
Place attachment clutch in "DISENGAGED"
position.
•
Lower attachment lift lever to its lowest position.
•
Roll belt off engine pulley (M) and belt keepers (G).
•
Remove retainer spring (K), slide collar (L) off and
push housing guide (P) out of bracket.
•
Remove clutch cable spring (Q) from idler arm (R).
•
Disconnect front link (E) from mower - remove retainer
spring and washer.
•
Go to either side of mower and disconnect mower
suspension arm (A) from chassis pin (B) and rear lift
link (C) from rear mower bracket (D) - remove retainer
springs and washers.
&
CAUTION:
AFTER REAR LIFT LINKS
ARE DISCONNECTED,
THE ATTACH=
MENT LiFT LEVER WiLL BE SPRING
LOADED. HAVE ATIG HT GRiP ON LiFT
LEVER WHEN CHANGING
POSiTiON
OF THE LEVER.
•
Slide mower out from under right side of tractor.
iMPORTANT:
IF AN ATTACHMENT OTHER THAN THE
MOWER
IS TO BE MOUNTED
ON THE TRACTOR,
REMOVE THE FRONT LINK (E) AND REAR LIFT LINKS
(C) FROM TRACTOR AND HOOKTHE CLUTCH SPRING
(Q) INTO THE CABLE GUIDE ON FRONT EDGE OF
LOWER DASH.
TO iNSTALL
MOWER
(See Fig. 21=25)
Be sure tractor is on level surface and engage parking brake.
Lower attachment lift lever to its lowest position.
CAUTION:
LIFT LEVER
iS SPRING
LOADED.
HAVE A TIGHT GRIP ON
LIFT LEVER, LOWER iT SLOWLY AND
ENGAGE iN LOWEST POSITION.
NOTE: Be sure mower side suspension arms (A) are point-
ing forward before sliding mower under tractor.
•
Slide mower under tractor until it is centered under
tractor.
Fig. 20
03042tex
18
Publicidad
Tabla de contenido
