Steren CLK-305 Manual De Instrucciones página 4

CONFIGURATION
Before to use, insert 2 AA batteries into the battery compartment. Remove the cover for
insertion, and then close the compartment properly. Be sure to place the polarities correctly.
To start to configure clock, press and hold the MODE button until the digits begin flashing.
Press MODE to change the settings selection and to save the changes made.
Press UP or DOWN to adjust the digits of the selection.
The adjustment sequence is as following:
Hours
Minutes
Year
Month
Day of the month
Alarm
(hours and minutes): Activate with the SNOOZE button, the
Snooze
Select between (1-60 min).
Activate with the SNOOZE button, the SNZ icon will be displayed on the screen. If you have activated the
snooze mode, you must press the SNOOZE button when the alarm sounds again (the SNZ icon will flash).
To deactivate it, press any other button except RESET.
Alarm date (Year, Month, Day).
Count down
(Press MODE to set the time that you want to the count run, then press the SNOOZE. At the
end of the count down, a tone will sound).
Count up
(Press the SNOOZE button to start count).
Count down
Hours
Seconds
Count up
Hours
Seconds
To change the temperature mode, just press the ºC / ºF button.
PLACING WATCH
To place the clock select the option that best fits to your needs:
(on a surface)
OPTION A
SPECIFICATIONS
Specifications may vary without previous notice
Input: 3 V - - - (2 x AA)
icon will be activated in the screen.
Minutes
Minutes
Perform one function at time
OPTION B (on a wall)