Husqvarna HB32 Manual Del Operador página 9

Check Water Inlet Screen / Connect Garden Hose
1. Inspect inlet screen. Remove debris or replace if
damaged.
2. Run water through garden hose (not to exceed 50 ft
(15 m) to clean out debris, then connect to water inlet.
NOTICE There must be at least 10 ft (3 m) of
unrestricted garden hose between the pressure washer
inlet and any device, such as a vacuum breaker, to
prevent pump damage.
3. Turn on water, point spray gun in safe direction, press
trigger lock and depress trigger to purge pump system
of air.
4. Attach spray wand to spray gun. Tighten by hand.
Step 4: Spray Tips
1. Select desired spray tip:
Inlet Screen
2. Pull spray wand quick connect collar back, insert
Low Pressure
Black Soap
Use to apply
detergent
General Rinse
Yellow, 15°
Siding /
Patios Decks
Driveways /
Garage Floors
spray tip and release. Tug spray tip to ensure it is
secure.
Delicate Rinse
White, 40°
Green, 25°
Cars / Vans
/ Trucks /
Outdoor
Furniture
Maximum
Rinse
Red, 0°
Paint Removal
/ Oil Stains
/ Rust Removal
9