D-Link DAS-3248 Guía De Instalación Rápida página 3

Front Panel Connection
Connect to another DAS-3248
EMS Configuration
This section shows how to prepare the system to perform basic
communication functions through Element Management System (EMS).
Perform initial configuration procedures as follows:
1. Click the EMS button on the screen of autorun to install EMS into
your PC.
2. Before you start to connect to EMS, it is necessary that your PC's
IP and DAS-3248's IP are in the same group. Note: DAS-3248's
default MGNT IP is 10.90.91.91.
3. Create management IPs into the DAS-3248 so that the authorized
IP agent can manage DAS-3248 through EMS. Connect to DAS-
3248 with RS-232 or Ethernet cable, and then write the IPs into
DAS-3248 by telnet or CLI. Input the following commands
sequentially:
a. create snmp comm community public
b. create snmp host ip 10.90.91. xxx community public, where
10.90.91.xxx is the IP of your PC.
c. create snmp traphost ip 10.90.91.xxx community public version
v1, where 10.90.91.xxx is the IP of your PC.
Note: if to use CLI, bits per second, data bits, parity, and flow
control should be set as 9600, 8, none and 1 respectively.
4. Launch the EMS and then log in with the "Admin" for both user
name and password. Click on to enter the EMS system.
3
Management
Station