Operation; Indicators; Charging; Adjusting Volume - Clarity CE50 Guia Del Usuario

Operation

Indicators

Below you can see an overview of the light indicators on CE50 HearIt Mobile
Flashing blue (R1):
Blue (R1):
Flashing blue (R3):
Green (R3-R7):
Flashing red (R5):

Charging

If the CE50 HearIt Mobile light indicator R5 flashes red during operation, or if the unit cannot be turned on, CE50 HearIt
Mobile requires recharging.
1. Connect the charger wire to CE50 HearIt Mobile's jack R11.
2. Connect the charger to a power source and turn on.
3. The light indicator R5 lights continuously red during recharging.
4. When CE50 HearIt Mobile is fully recharged, light indicator R5 lights continuously green.
* Plugs vary from country to country.
*
R11
1 2

Adjusting volume

1. Press receiver button R2+ (volume up) or R2- (volume down) to set comfortable listening level.
2. The receiver indicators R3 to R7 illuminate depending on volume level.
R2+
R2-
2
1
Please note:
• The maximum volume level has been reached if all five indicators R3 to R7 are illuminated. If the signal is still too weak,
adjust the volume on your mobile telephone or contact your hearing care professionel for adjustment of the telecoil
in the hearing aid.
Incoming call
Wireless Bluetooth call activated
No Bluetooth connection
Volume level
Battery low
Please note:
• We recommend fully charging
batteries before use. However,
partly charging the units does not
inflict damage to them.
3
- +
4 Charged
8
Operation

Accepting an incoming call

1. When a call comes in, a ringing tone will be heard in the hearing aid or headphones and the receiver indicator
R1 starts blinking blue.
2. Press the button R1 to accept the call.
3. Press the button R1 to end the call.
2
1
R1 R1
Please note:
• Only make a single short push to accept or end a call. It may take a couple of seconds before a call is completely
connected or disconnected.
• The ringing tone of the mobile telephone call may be the same sound as heard from the mobile telephone itself
depending on the mobile telephone used.
• If CE50 HearIt Mobile is turned off when a mobile telephone call comes in, that specific call cannot be answered
or ended using CE50 HearIt Mobile.

Making a mobile telephone call

1. Turn on CE50 HearIt Mobile by pressing the button R1 for up to five seconds.
2. Enter the dial number on the mobile telephone and pick up the handset.
3. The call is automatically transferred to CE50 HearIt Mobile.
4. To end the call, press the button R1 or end the call on the mobile telephone.

Rejecting an incoming call

1. When a call comes in, a ringing tone will be heard in the hearing aid or headphones and the receiver indicator
R1 starts blinking blue.
2. Press receiver button R2- (volume down) for two seconds to reject the call.
R2-
1
R1
2

Cleaning and maintenance

1. Any dirt, moisture or grease should be cleaned by using a dry or damp cloth.
ENG
3
R1
9