Eaton PowerXL DX-NET-SWD3 Manual De Instrucciones página 31

4.2.2.4 Red – S4: operación, perfil 2
Si se utiliza el perfil 2 con PNU 928,0 = 1 - 5, es válido el diagrama de estado
general representado abajo. Las transiciones se realizan mediante control de
los correspondientes bits.
S4.1: Idle Operation
Bit 8, 10 = 0
Ramp Up
Idle
Bit 4 = 1 (EN_Ramp) and
Bit 4 = 0
Bit 5 = 1 (Freeze) and
(EN_Ramp)
Bit 6 = 1 (EN_Set)
S4.2: Ramping Up Operation
Bit 8 = 1; Bit 10 = 0
Top of Ramp
S4.5: TOR Operation
Bit 8, 10 = 1
Figura 16:Diagrama de estado: red – S4 (perfil 2)
DX-NET-SWD 06/13 MN04012009Z-ES www.eaton.com
Idle
Bit 4 = 0
(EN_Ramp)
S4.3: Paused Operation
Bit 4 = 1 (EN_Ramp) and
Bit 8 = 1; Bit 10 = 0
Bit 5 = 1 (Freeze) and
Bit 6 = 0 (EN_Set)
Pause
Bit 4 = 1 (EN_Ramp) and
Bit 5 = 0 (Freeze) and
Ramp Up
Bit 4 = 1 (EN_Ramp) and
Bit 5 = 1 (Freeze) and
Bit 6 = 1 (EN_Set)
Ramp Down
Bit 4 = 1 (EN_Ramp) and
Bit 5 = 1 (Freeze) and
Bit 6 = 0 (EN_Set)
4 Puesta en servicio
4.2 Programación
Ramp Down
Bottom
of Ramp
S4.4: Ramping Down Operation
Bit 8 = 1; Bit 10 = 0
27