Installing The Fire 30 / Fire 50; Connecting The Gas Supply; Positioning The Logs - Dru Verwarming FIRE COUNTRY RC Manual De Instalación Y Guía Del Usuario

INSTRUCTIONS FOR INSTALLATION
right-hand corner.
• If the gas supply hose is to enter the appliance at the
side, lay it across the bottom behind the foot of the
heater (see fig. 2).
• Stand the appliance against the back and, if applicable, the
side.
Ensure that the air gap under the heater stays open to
allow a constant air supply to the burner; failure to
observe this could result in the formation of harmful
gasses.
Installing the Fire 30 / Fire 50 (fig. 3)
The Fire 30 and the Fire 50 are intended for installation
on the grate of an existing fireplace. To do this:
• If necessary, make a hole of at least ø 22 in the existing
grate.
• The gas connection at the bottom of the burner tray
should be poked through the grate.
• Put the washer (B) on the gas connection and fix the
burner tray tightly with the brass nut (C).
• Now screw the second brass nut (D) and the elbow joint
with packing (E) onto the gas connection.
• Fit the bracket with gas control block (A) between the
nut (D) and the joint (E).
• Tighten the brass nut (D) firmly.
• Connect the gas control block (connection F) with an
elbow joint (E) to the piping (G).
• Screw the oxypilot connection into the gas control block
(connection H).
N.B.: when connecting the oxypilot, the coupling nut in
connection H should first be tightened by hand and then
tightened another quarter turn with an open-ended
spanner.
• Connect the pilot light to the gas control block
(connections K and L) using the pilot-light pipe (J).
• If there is an ashpan, remove the back to make it fit.
• Check that all connections are gastight.

Connecting the Gas Supply

An approved connecting tap with coupling should be
used in the supply hose (In Belgium this must be B.G.V.
approved). Furthermore:
fig. 3
• Expel all air from the supply pipes/hoses before coupling
to the appliance.
• Do not turn the coupling tap when connecting it to the
gas supply.
• Avoid any pressure on the control tap and pipes.
• Check that all connections are gastight.

Positioning the logs

Position the logs for the Fire Country and the Fire 50 as
follows (fig. 6):
• Lay the large log against the back of the fire.
• Fill the burner tray with vermiculite (4 bags).
• Make sure that no vermiculite gets onto or into the
oxypilot, as this could prevent the pilot light from
working correctly.
• Sprinkle the bag of embers (the bag with black contents)
on top of the vermiculite to create a glowing effect on
the burner bed.
• Now lay the other logs as illustrated.
Position the logs for the Fire 30 as follows (fig 7+8):
• Fill the burner tray with vermiculite (4 bags).
• Make sure that no vermiculite gets onto or into the
oxypilot, as this could prevent the pilot light from
working correctly.
9
fig. 6
fig. 7
Fire