Dipswitch For Time Mode Settings; Stripping The Cable - BADU JET Wave Instrucciones Para El Manejo

Installation
the lighting circuit, this segment can light up briefly due to the
inrush current in the LED lighting module!
*FV* lights up if the voltage in the microprocessor overloads.
Green and orange LEDs on the circuit board
 See "Fig. 23" on page 38.
*V* green LED lights up: Power supply present in the circuit board
[Volt].
*M* orange LED lights up: Motor protection has triggered (over
current).
Check the motor protection settings.

Circuit board fuse
 See "Fig. 23" on page 38.
*Si* Replaceable fuse: 3.15 A T
The fuse only needs replacing if the green LED [V] is not lit up.
5.5.3

Dipswitch for time mode settings

LED light duration
120 min
180 min
manual
Fig. 25
5.5.4

Stripping the cable

 The cable for the power supply should be stripped to a length
of 15 – 17 cm.
40 EN
60 min
ON
1
Pump run time
ON
2 7 8
30 min
15 min
45 min
manual
WG27.50.111-2-P
01|2018