General Guidelines; User Manual - Perel SSE025 Manual Del Usuario

1. Introduction
To all residents of the European Union
Important environmental information about this product
This symbol on the device or the package indicates that disposal of the device after its lifecycle
could harm the environment. Do not dispose of the unit (or batteries) as unsorted municipal
waste; it should be taken to a specialized company for recycling. This device should be returned
to your distributor or to a local recycling service. Respect the local environmental rules.
If in doubt, contact your local waste disposal authorities.
Thank you for choosing Perel! Please read the manual thoroughly before bringing this device into service.
If the device was damaged in transit, do not install or use it and contact your dealer.
2.

General Guidelines

Refer to the Velleman® Service and Quality Warranty on the last pages of this manual.

Familiarise yourself with the functions of the device before actually using it. Any damage that may
occur will most probably be due to unprofessional use of the device.

Use the original packaging if the device is to be transported.

All modifications of the device are forbidden for safety reasons.

Only use the device for its intended purpose. All other uses may lead to short circuits, burns,
electroshocks, crash, etc. Using the device in an unauthorised way will void the warranty.
3. Features

electronic lock: easy to operate and programmable with 3 to 8 digits

manual override key system

LEDs for security and power status

buzzer feedback for each operation
4. Opening the Safe with the Override Keys
For your convenience we have engineered a manual override system in case you forget or misplace your
code combination. Also, the safe should be opened with these keys at first use.
1. Remove the small plate below the knob.
2. Insert the key into the keyhole and turn it in a clockwise direction.
3. Turn the knob towards the right.
WARNING: Stock your override keys in a safe place. Do not keep them in the safe!
5. Batteries
Remark: The batteries are in a sealed plastic bag, which is fixed to the inside of the safe
with adhesive tape.
WARNING: If the batteries are low, the red indicator will warn you immediately. Test the
batteries by entering your code combination. Open the door. If the batteries are low, the
red indicator will light. The indicator will not light if the batteries are in order.
Installing/Replacing the Batteries
1. Open the safe and push the battery cover on the back of the door.
2. Install the new batteries or take out the old batteries and replace them with four AA (1.5 V, R06)
alkaline batteries.
3. Programme or re-programme the code (see Programming the Code).
V. 03 – 12/06/2015
SSE025

USER MANUAL

3 ©Velleman nv