System Overview - Coleman HWOD 2302-A Serie Instrucciones De Uso

General Safety Information (continued)
Failure to comply with the precautions and instructions provided with
this product can result in death, serious bodily injury and property loss
or damage from hazards of fire, explosion, burn, asphyxiation, and/or
carbon monoxide poisoning.
Only persons who can understand and follow the instructions should
use or service this product.
If you need assistance or information such as an instruction manual or
labels, contact The Coleman Company, Inc.
WARNING
When using electrical products, basic precautions should always be
practiced including the following:
1. READ AND FOLLOW ALL SAFETY INSTRUCTIONS.
2. Read and follow all instructions that are on the product or provided
with the product.
3. For a cord-connected or direct plug-in power unit, do not use an
extension cord.
4. Do not install or use within 10 feet (3 m) of a pool.
5. Do not use in a bathroom.
WARNING: Risk of Electric Shock. When used outdoors, install only
to a covered Class A GFCI protected receptacle that is weatherproof
with the power unit connected to the receptacle. If one is not provided,
contact a qualified electrician for proper installation. Ensure that the
power unit and cord do not interfere with completely closing the
receptacle cover.
WARNING: Never leave heater unattended when hot or in use. Do not touch metal parts and venting holes of the heater, which may get very hot when
in use. Keep out of reach of children. THIS APPLIANCE IS NOT INTENDED FOR THE SUPPLY OF DRINKING WATER.

System Overview

Thank you for purchasing Coleman's Hot Water on Demand
Regulator –
where the gas cylinder
is to be connected to.
Match Extension –
Use match extension
to hold and insert a
lighted match through
flame window.
Flame Window –
check status of pilot
light and burner flame,
or insert a lit match
through this window
to light the heater
USB Ports x 2 –
manually.
(Available on
model 2302-A only)
For charging USB
compatible devices.
(voltage: 5V each;
current: ≤1A total)
DANGER
TM
Storage compartment for recharger cord
& match extension–
12V auto recharger and 120V household
recharger cords are stored here (120V
charger Available on model 2302-A only)
Display panel (varies by model)-
A display that shows the status of
the appliance, like water temperature,
error codes etc. See section "Chart of
Indicators"
• This product is fueled by propane gas. Propane gas is invisible,
odorless, and flammable. An odorant is normally added to help
detect leaks and can be described as a "rotten egg" smell. The
odorant can fade over time so leaking gas is not always detectable
by smell alone.
• Propane gas is heavier than air and leaking propane will sink to
the lowest level possible. It can ignite by ignition sources including
matches, lighters, sparks or open flames of any kind many feet
away from the original leak. Use only propane gas set up for vapor
withdrawal.
• Gas cylinders must be stored outdoors in a well ventilated area out of
the reach of children, any indoor storage shall comply with
AS/NZS 1596.
• Disconnect propane before storing the heater.
• Keep all connections and fittings clean. Inspect propane cylinder and
propane connections for damage before attaching.
• During set up, check all connections and fittings for leaks using
soapy water. Never use a flame. Bubbles indicate a leak. Check that
the connection is not cross-threaded and that it is tight. Perform
another leak check. If there is still a leak, remove the cylinder and
contact Coleman for service or repairs.
• Use for water heating only. Never alter in any way or use with any
device or part not expressly approved by Coleman.
• Always use in an upright position.
Before You Go
unit.
Shower (varies by model)-
Detachable handheld shower
Shower Arm–
Adjustable shower
arm that holds the
shower in place.
Control knob – press to
turn in a counterclockwise
direction. Adjust knob to
desired water temperature.
connects to shower.
WARNING
WARNING
SERVICE SAFETY
Fuse Socket -
Replaceable fuse is
installed here.
Recharging Port –
plug 12V and 120V
Recharger cords
Water outlet – Water inlet –
connects to pump.
Power socket for pump –
Power the pump by
connecting the pump
power cord to this socket.
Air Vents –
Do not block air
vents.
Battery compartment –
12 volt / 2000 mAh
rechargeable Li-Ion battery
is located in compartment.
Battery operates the pump
& circuitry.
Main Power Switch–
(Available on 2302-A
only)
3