IntesisHome PA-AW-WIFI-1 Guida Rapida página 5

IntesisHome ® PA-AW-WIFI-1
3.- Select your AP from the list of available APs
by clicking on select button.
(In this example APWifi )
If the desired AP is not showed press the
Refresh button
If there is no signal, or signal level is lower
than proposed, please visit our connectivity
section at www.intesishome.com/connectivity
to try fi nd the best solution for your case.
IMPORTANT: Make sure that Signal is Good,
Very Good or Excellent. If not, please move
the AP closer to the Intesishome
4.- If the network is protected, write the correct
password and click next button
This screen may change depending on the security
protocol used by your AP.
If using WEP encryption and you get an error when
introducing the password, please visit our Password
Generator at
http://www.intesishome.com/support/keygen/
5.- Confi rm that you want to connect to that network
by clicking Save and apply button
(Confi guration process has been completed)
4.3 Connection result
If connection has been successful, IntesisHome
document. If the device LED follows the sequence indicated, you have correctly fi nished confi guration
process. Now you can enjoy IntesisHome
user and also to confi gure the installed device(s) and visit http://www.intesishome.com/downloads to get
the last version of our application.
If your device is not following the proposed sequence and does not work properly, please check the
LED status table in section 5 of this document and if problem still persist visit our support site at www.
intesishome.com/support.
® Device.
®
LED will start the sequence shown in section 5 of this
® . Go to the user area at user.intesishome.com to register as a
USER'S QUICK START GUIDE
EN
5