IntesisHome PA-AC-WIFI-1 Guida Rapida página 3

IntesisBox PA-AC-WIFI-1
®
®
4. IntesisHome device connection procedure
Before start rt r ing the set up process, make sure that the Air-Conditioning unit (AC) is connected to the
®
power supply line and IntesisHome LED is steady green.
There are two connection modes available: with WPS and without WPS.
���� �� � : Check your Access Point (AP) user's manual to find (if available) the WPS button or WPS
activation procedure
4.1 Connection with WPS
This method assumes that your Access Point (AP) support rt r s WPS connection mode.
®
1.- Press IntesisHome device button
(IntesisHome® device LED start rt r s blinking blue)
2.- Activate your AP WPS mode. IntesisHome
If connection has been successful, IntesisHome
off ff f . It not, please check LED status table and/or visit www.intesishome.com/s /s / upport rt r .
4.2 Connection without WPS
This method assumes that your AP does not support rt r WPS connection mode and that you have a Wi-Fi
compatible device (laptop, mobile phone, tablet, etc.)
1.- Connect your Wi-Fi device to the
®
IntesisHome Wi-Fi network
(Network that start rt r s with ���� �� � �������� �� �
2.- Open the web browser of your Wi-Fi device
and write any URL y y
® ®
(IntesisHome welcome site will open)
3.- Select your AP from the list of available APs
by clicking on ������ button.
(In this example ���� � �� �� � ) ��
If the desired AP is not showed press the
browser ���� �� � � �� � �� �������
4
USER'S QUICK START GUIDE
U U s s e e r r 's s Q Q u u i i c c k k St Sta a r r t t
®
device LED will change blinking color
®
LED will blink up to one minute and then it will turn
IntesisBox PA-AC-WIFI-1
®
G G u u i i d d e e
4.- If the network is protected, write the correct
password and click ���
This screen may change depending on the security ty t
protocol used by your AP.
5.- Confirm that you want to connect to that
network by clicking ���� ��� ���
If connection has been successful, IntesisHome
off ff f . It not, please visit www.intesishome.com/support rt r .
Color (s)
Green
Blue
Green
Yellow
Red /Green
Yellow /Green
®
5. IntesisHome
Go to the user area at www.intesishome.com to register as a user and also to configure the installed
device(s).
6. FAQ and support
For any question or problem related with the product or the installation procedure, please visit our
support rt r center at www.intesishome.com/support rt r .
USER'S QUICK START GUIDE
U U
�� � � button
� �� �� � button ��
®
LED will blink up to one minute and then it will turn
LED status table
Behavior Description
Steady Ready to be connected
Blink Performing WPS connection
Blink Connecting to access point and server
Blink Downloading configuration. Wait
Alternate Error Connecting to Access point. Try to connect
blink again and make sure you write the correct password
Alternate Server not reached. Check if there is Internet
blink connectivity on your Access Point
Device registration
EN
s s e e r r 's s Q Q u u i i c c k k St Sta a r r t t G G u u i i d d e e
5