Gunnebo Industries DLP Guia Del Usuario página 6

Inspection criteria
• Ensure that the bolt, nut and washer are of the correct size, quality and
length, and only Gunnebo Industrier original equipment must be used.
• Ensure compatibility of bolt thread and tapped hole - control of the
torque.
• The lifting point should be complete.
• The working load limit and manufacturers stamp should be clearly
visible.
• Check for deformation of the component parts such as body, load ring
and bolt.
• Check for mechanical damage, such as notches, particularly in high
stress areas.
• Wear should be no more than 10% of cross sectional diameter. For
measurements of the DLP please see the Gunnebo Industries product
catalogue.
• Evidence of corrosion.
• Evidence of cracks.
• Damage to the bolt, nut and/or thread.
• The body of the DLP must be free to rotate.
After fitting, an inspection for suitability should be carried out by a person
with sufficient knowledge at least annually or more frequently if conditions
merit. Inspections shall also be carried out after any damage or special
occurances.
This safety instruction/declaration of the manufacturer must be kept on
file for the lifetime of the product.
Please inspect all lifting points prior to use. Damage, incorrect
assembly or improper use may result in serious injuries and/or
EC-Declaration of the manufacturer
According to the Machinery Directive 2006/42/EC, annex II B.
We hereby declare that the design and construction of the equipment
detailed within this document, adheres to the appropriate level of
health and safety of the corresponding EC regulation.
Any un-authorized modification and/or any incorrect use of the
equipment not adhered to within these user instructions waivers this
declaration invalid.
Failure to carry out the recommended maintenance and testing waivers
this declaration invalid.
ATTENTION:
material damage.
6