Wolf DD30 Manual Del Usuario página 9

IN S TA L L AT I O N
Installation
D OWN DR A F T
Install the top mounting brackets using the #4 sheet
1
metal screws provided. Refer to the illustration below.
Install the lower mounting brackets using the #8 x 32
2
sheet metal screws provided, but do not tighten. The
brackets need to be adjusted once the downdraft is
placed in the opening. Refer to the illustration below.
Top mounting bracket Bottom leveling bracket
TR AN SI TIO N
For internal blowers, remove the existing 10"
transition. Refer to the illustration below.
For in-line and remote blowers with a front discharge, leave
the 10" round transition in place.
(254)
For in-line and remote blowers with a rear discharge,
remove the 10" round transition from the front and the
(254)
solid cover from the rear of the downdraft, then reinstall the
transition on the rear and the solid cover on the front.
Remove transition
round
(254)
wolfappliance.com | 9