To Change The Factory Settings; Changing The Temperature Time Periods - Carrier Comfort Serie Manual Del Usuario

Programming the Control

To change the factory settings

1. Press and hold the comfort button
( or or
seconds. The set temperature along with the symbol
heat ( ) or cool (
flash.
2. Select the desired zone by pressing the zone (
button repeatedly.
3. If zone 1 or 2 is selected, press the mode (M) button
to switch between heat (
4. Press the up or down button on the right side of
the display until you reach the desired temperature
setting for the current mode of operation. At this
moment the triangle icon (
comfort button (
5. Press the up or down button on the right side of
the display until you reach the desired temperature
setting.
6. Pressing one of the other two Touch 'N' Go button,
item 4 to 5 can be repeated.
7. If needed select a different zone and repeat steps 3
to 6.
8. Press OK button to confirm changes and exit from the
Comfort change mode.

Changing the temperature time periods

After you have set temperature settings for home, away and
sleep, you can program the time of day you want to use for
those temperature settings.
Time ranges are called periods; zone 1 and zone 2 have
maximum 6 periods; zone 3 has maximum 4 periods.
Period
P1
P2
P3
P4
P5
P6
Note: zone 1 and zone 2 have the same time periods.
) to be changed for about five
) or domestic water ( ) will
) and cool ( ).
) above the pressed
) will start flashing.
Zone 1 / Zone 2
6:00
8:00
12:00
14:00
18:00
22:00
)
Periods are identified on the display as P1, P2, P3, P4, P5
and P6.
The thermostat has preset periods (see below), but you can
change these to fit your lifestyle.
To select the number of periods, refer to the (user)
parameters table in the unit documentation.
Period Start Time
Zone 3
6:00
8:00
18:00
24:00
Not available
Not available
7