LEGRAND Wiremold OFR Serie Instrucciones De Instalación

OFR Series
Overfloor Raceway Device Box
I N S T L L T I O N I N S T R U C T I O N S
Installation Instruction No.: 1 009 725 – February 2011
PRODUCTS COVERED:
2-Gang Device Box (OFR48-2) and Device Plates (OFR47-B, OFR47-D, OFR47-R, OFR47-2 , OFR47-U,
OFR47-V, OFR47-U2
1. Insert device box connecting tabs into outer channels of
raceway base mounted to floor. Tighten (2) #8-32 screws
to secure.
4. Insert divider tabs in one of the three sets of mounting
bridges in the base. Select the set of bridges that is
appropriate for the layout of wires in the raceway.
5. Mount the devices and device plates
to the device box.
• For device plates used with NEM
standard devices (OFR47-D,
OFR47-R), mount as shown in 5 .
• For device plates, which mount
communications and V devices
(OFR47-2 , OFR47-U, OFR47-V,
OFR47-U2 ), remove break away
tabs as shown in 5B.
OFR48-2, OFR48-4, OFR48-4GX, OFR47-B, OFR47-D, OFR47-R, OFR47-2 ,
OFR47-U, OFR47-V, OFR47-U2
5
Legrand/Wiremold electrical systems conform to and should be properly
grounded in compliance with requirements of the current National
Electrical Code or codes administered by local authorities.
ll electrical products may present a possible shock or fire
hazard if improperly installed or used. Legrand/Wiremold electrical
products may bear the mark of a Nationally Recognized Testing
Laboratory (NRTL) and should be installed in conformance with current
local and/or the National Electrical Code.
IMPORT NT: Please read all instructions
before beginning.
2. Using #8 fasteners, install base of raceway directly on
top of existing floor covering. The screw type should be
appropriate for the type of floor, which the raceway is
being installed on.
3. Place wires in raceway base and attach raceway cover
to raceway base.
5B