Air Direction; Ventilation Control - GE Zoneline AZ45 Manual De Proprietário

Using the Zoneline
To Remove the Room Front
Additional controls are located behind the room cover.
To remove: Pull out at the bottom to release it from the

Air Direction

screws and the room cover.

Ventilation Control*

NOTE: Two shipping screws must be removed from the
vent door before use. See the Installation Instructions in the
back of this manual. If you do not plan to use the ventilation
feature, leave the two screws in place.
When set at the closed position, only the air inside the
room is circulated and filtered.
When set in an open position, some outdoor air will be
efficiency.
Energy Tip: Keep the vent control in the closed position to
prevent unconditioned air from entering the room.
* Not on Make Up Air Module
49-5000355 Rev. 2
To replace: Align and place the top rail of the room cover
Remove the
shipping screws
(if operation is
7