ICAN 30-300 Instrucciones De Uso página 43

CLEANING-DISINFECTION-DRYING-STORAGE (GB) 6
CLEANING:
It is recommended that the mask be cleaned after use. Clean the mask and the other
components (except the filters), in lukewarm water to which a mild detergent has
been added (e.g., washing-up liquid or a liquid washing machine detergent) which
does not contain perborate. If the mask is very dirty, a brush can be used to clean it.
Do not use solvents (e.g., benzine or spirit) or very warm water (max. 60°C). The
mask should be rinsed thoroughly in lukewarm running water (refer to cleaning
intervals in table 3, page 8).
DISINFECTION:
Disinfect the mask components in a suitable solution after use. Use a disinfectant
such as "MULTIDOR". Follow the instructions carefully (refer to disinfection
intervals in table 3, page 8).
DRYING:
ICAN HALF MASK should be air-dried or dried in a drying cabinet at a
temperature not exceeding 60°C. Avoid direct sunlight.
STORAGE:
Store ICAN HALF MASK in airtight and light-proof packaging in a cool and dry
place.
NOTE!
Silicone has a tendency to absorb detergents and disinfectants. Irritation of the
skin can occur as a result.
Therefore:
1. Reduce the time the substances are in contact with the mask, which is stated in
the instructions, to a minimum.
2. Rinse thoroughly in running water for 10 minutes, after cleaning and
disinfection of ICAN HALF MASK 30-500.
30-300/ 500 JULI 02 REV. 01. (GB)
 copyright 2002