Potential For Radio/Television Interference; Troubleshooting - Health Plus BPS-FD1 Manual De Instrucciones

BPS-FD1.qxd 7/13/06 9:55 AM
POTENTIAL FOR RADIO/TELEVISION
INTERFERENCE
For USA only:
This product has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of FCC rules. These limits
are designed to provide reasonable protection against harmful
interference in a residential installation. The product generates, uses,
and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to
radio communications. However, there is no guarantee that interference
will not occur in a particular installation. If the product does cause harm-
ful interference to radio or television reception, which can be deter-
mined by turning the product on and off, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the product and the receiver.
• Connect the product into an outlet on a circuit
different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
For Canada only:
This digital apparatus does not exceed the
Class B limits for radio noise emissions from digital apparatus as set
out in the interference-causing equipment standard entitled "Digital
Apparatus", ICES-003 of the Canadian Department of
Communications.
Cet appareil numérique respecte les limites
de bruits radioeléctriques applicables aux
appareils numériques de Classe B prescrites
dans la norme sur le matériel brouilleur:
"Appareils Numériques", ICES-003 édictée par
le ministre des communications.
Page 21
21

TROUBLESHOOTING

If any abnormality arises during use, please check the following points
POSSIBLE
SYMPTOMS
CAUSES
Unit does not turn on Batteries have
when the START/STOP run down.
button is pushed.
Battery polarities
have been positioned
incorrectly.
EE measurement error Cuff has been placed
symbol shown on dis- incorrectly.
play or the blood pres-
sure value is displayed
Did you talk or move
excessively low
during measurement?
(or high).
Shaking of the arm with
the cuff on.
E1 error symbol shown Air circuit abnormality.
on display Cuff tube may not be
plugged into monitor
correctly.
E2 error symbol shown Inflation pressure
on display exceeding 300 mmHg.
E3 error symbol shown Data error.
on display
Note: If the unit still does not work, contact Health Plus Consumer
Relations. Under no circumstance should you disassemble or
attempt to repair the unit by yourself. Contact information for
Health Plus Consumer Relations Department can be found on
the warranty page.
22
CORRECTION
Replace them with
four new AA
alkaline batteries.
Re-insert the batteries in
the correct positions.
Wrap the cuff properly
so that it is positioned
correctly.
Measure again. Keep
arm steady during
measurement.
Check cuff connection.
Measure again.
Switch the unit off, then
measure again.
Remove and reload the
batteries.