Troubleshooting - Westinghouse 20V plus Manual De Usuario

TROUBLESHOOTING

PROBLEM
Slow running, noisy or hot
blades
Unit will not start
Battery will not charge
POSSIBLE CAUSE
Dry, corroded blades
Blades or blade support bent
Bent or damaged teeth
Loose blade bolts
Battery not installed properly
Battery not charged
Battery not inserted into charger
Charger not plugged in
Surrounding air temperature too
hot or too cold
POSSIBLE SOLUTION
Check battery installation
Straighten blade or blade
support
Straighten teeth
Tighten blade bolts.
Check battery installation
Check battery charging re-
quirements
Insert battery into charger
until red LED appears
Plug charger into a working
outlet.
Check current at receptacle
by plugging in a lamp or other
appliance.
Check to see if receptacle is
connected to a light switch
which turns power off when
you turn out the lights.
Move charger and tool to a
surrounding air temperature of
above 40 degree F (4.5°C) or
below 105 degree F (+40.5°C).
13