Using Your Immersion Blender - all-clad KZ800D51 Guia Del Usuario

U S I N G Y O U R I M M E R S I O N B L E N D E R
Before first use, carefully wipe clean and dry all parts. Refer to the CLEANING section.
Charging your blender/ Battery Life
1. The battery in your All CLAD Cordless Hand Blender has not been fully charged. Before the first use of this
appliance, the battery must be charged until the BLUE battery indicator light illuminates. With a full charge, your
stick blender will run for approximately 6-9 minutes, depending on load. Your stick blender will be fully charged in
approximately 2-2.5 hours. You can "quick charge" your stick blender for 3 minutes of run time in 30 minutes of charge.
2. Charging: When flashing RED, battery is in charging status; when BLUE Indicator light is on, your battery is
fully charged.
3. In operation mode: BLUE Indicator lights up.
4. When flashing slowly in BLUE, battery level between 24-10%. When flashing fast, battery level will go down to
9-1%, the unit does not operate when the light turns off.
5. Running out of battery: When no indication at all, you have zero battery power and need to charge.
When using the blender
1. Insert the blending shaft into the blender body and turn counter clock-wise to lock in
place. Use the line on the blender body and the icons on the blender shaft as a guide.
2. Set the desired speed from 1 to 5 by turning the speed selection dial. It is
recommended to set speed from the lowest power setting and gradually increase
it to the desired speed.
3. Immerse the blending shaft into the ingredients and cover the blade.
4. Press SAFETY LOCK button
to begin blending, as illustrated. Only allow the blender shaft to be immersed in
food or liquid.
5. Slowly move the blender shaft up and down or in a circular motion to process
food evenly.
followed by holding on the POWER button
EN
9