Shure PSM 600 Guia Del Usuario página 7

Stereo Control
The P6HW will typically be used with stereo control. In Stereo
control, the P6HW receives a stereo signal, such as monitor left
and monitor right, which is then transmitted to the earphone as a
stereo signal.
1. Connect the 5-pin end of the Y-cable to the INPUT connector
of the P6HW. Remember that the RED dot on the connector
must be facing out.
2. Connect the XLR end of the Y-cable marked R to the Right
monitor output.
3. Connect the XLR end of the Y-cable marked L to the Left mon-
itor output.
4. Set DIP switch 2 to STEREO.
5. Proceed with the operation steps (see Operation).
MixMode Control
In MixMode control, the P6HW receives and sends two differ-
ent mono monitor mixes. The Balance knob adjusts between the
two mixes. In a typical application, a singer in a band may choose
to have the engineer mix all instruments in channel 1 and his/her
voice in channel 2. By adjusting the balance knob, the singer can
control the volume of the voice compared to the rest of the band.
The following illustration shows how the balance control would af-
fect the volume between the two channels in this application. Both
channels come through left and right earphones as a mono signal,
and both mixes are at equal volume at the center detent.
CH 1
BAND VOLUME LOUDER
1. Connect the 5–pin end of the Y-cable to the INPUT connector
of the P6HW. Remember that the RED dot on the connector
must be facing out.
2. Connect the XLR end of the Y-cable with the RED tubing to
the monitor mix 1 output.
3. Connect the other XLR end of the Y-cable to the Left monitor
mix 2 output.
4. Set DIP switch 2 to MixMode.
5. Proceed with the operation steps (see Operation).
6. While performing, use the balance knob to adjust the volume
balance between the two mixes.
Mono Control
If the monitor mix is mono, only one signal is sent through the
P6HW to both the left and right earphones.
1. Connect the mono output of the mixer to either the left or right
audio input of the P6HW using the supplied Dual XLR to 5–pin
Y-adapter cable.
2. Set DIP switch 2 to MixMode.
3. Turn the balance knob all the way to the side where the mono
signal comes through.
4. Proceed with the operation steps (see Operation).
R
L
CH 2
ENGLISH
L
CH 1
VOICE VOLUME LOUDER
5
R
CH 2