Control Panel; Light Button - Pur Line FRESH AIR 140 Manual De Instrucciones

CONTROL PANEL

Connect the power. All indicators will be on 1 second and then off. When Power, Wind Speed, Light and
Timer Buttons are on again, it means the unit is in standby mode.
Power Button
Press the power button, the appliance turns on auto default mode, the corresponding indicator will be
on, after 30S of pre-working, the light ring will be on with the color acording the air quality.
Wind Speed Button
- When turned on, press the Wind Speed Button to adjust the wind speed among the circulation of S-H-
Auto grade, and the corresponding indicators will be on. Each time you press the button, the buzzer
rings once.
- When the appliance is in auto mode, the wind speed will be adjusted according to the air quality.
- When the appliance is in sleep mode, if there is no operation for 5 seconds, the machine will enter sleep
mode.

Light Button

Press the light button, the light will be changed among off-soft-standard, each me you press it, the
buzzer will ring once.
Timer/WiFi Button
- When in operation, press the Timer Button to set timer among the circulation of 2H, 4H and 8H. Each
time you press the the button, the buzzer rings once, and the corresponding indicator will be on.
- Long press the Timer/WiFi Button for 5 seconds to start WiFi function, and the indicator will be on. If you
turn off the machine, the WiFi function needs to be reset when you turn on the machine again.
Air quality sensor
When the air purifier is in auto mode, the circle of light in top part will display different colors according
to the air quality:
- blue light: good air quanlity is (PM2.5≤75pg/m³), the wind speed will auto-adjust to low speed.
- yellow light: moderate air quanlity (75<PM2.5≤150pg/m³), the wind speed will auto-adjust to mid
speed.
- red light: bad air quanlity (PM2.5>150pg/m³), the wind speed will auto-adjust to high speed.
Filter Replace Reminder
- When in operation, when the device detects the filter is saturated after running for 2200 hours, the filter
light indicator will keep flashing in red. Long press the Wind Speed Button for 7s to stop flashing light
and to reset after installing a new filter.
EN
11