Delay Start - Black+Decker PR100SD Manual De Uso Y Cuidado

SLOW COOK
This is not a pressurized setting, but is intended to be used with the lid in
place. When slow cooking, it is extremely important that you do not often
open the lid to check on the cooking progress. Each time the lid is opened,
your cook time will need to be increased.
1. Place the cooking bowl in the interior of the pressure cooker.
2. Place all necessary ingredients into the cooking bowl. Do not fill above
the MAX fill line.
3. Place the lid on the pressure cooker and rotate
clockwise to align the "
with the "CLOSE
cooker. The pressure release valve should be left
in the release position (K) during slow cooking.
4. Press either the Slow Cook High
Cook Low
flashing above the selected function, and the LED
display will flash with 6 hour default for HIGH and
an 8 hour default for LOW. Press the + or – buttons to adjust the time.
5. Press the START button
function and the timer will begin to countdown.
6. Once the time is up, the pressure cooker will automatically switch to
keep warm. A flashing red light will illuminate above the Keep Warm
button and the timer will flash and begin to count up.
7. To open the lid: Hold the lid handle and turn the lid counter-clockwise
until the "
the pressure cooker; lift the lid straight up and off the pressure cooker.
Note: Steam may escape when opening the lid. Always lift the lid straight off
and use caution when opening.
8. Always allow the pressure cooker to fully cool before cleaning and
storage.
Note: Do not cut meats in the cooking bowl as this may scratch the finish.

DELAY START

The delay start feature is ideal for planning out meals on your schedule,
allowing you to delay cooking for a set amount of time. This feature works
for all functions except browning, slow cook, and keep warm. Always be sure
to follow food safety recommendations while cooking.
See https://www.foodsafety.gov/ for additional information.
1. Once a function is selected (see "Preset Cooking Functions") a red light
will flash above the selected function and a default time will appear
on the LED display. If the time needs to be adjusted, press the + or –
buttons to select the correct time.
:
" marking on the lid
" marking on the pressure
button. A red light will begin
. The red light will turn solid above the chosen
" marking on the lid aligns with the "OPEN
:
or the Slow
16
K
" marking on