Black+Decker PR100SD Manual De Uso Y Cuidado página 20

PROBLEM
Display
flashes 3
blinking bars
but timer
doesn't start
Display flashes
"C5" and the
pressure cooker
shuts down
Display remains
blank after
connecting the
power cord
All LEDs C1
flash with code
a code
C2
appearing
code
on screen
C5
code
C6
code
POSSIBLE CAUSE
Working Pressure
pressure release valve
isn't is not in the
reached seal position
inside
Rubber
during
gasket is not
preheating
in place
cycle
Red interlock
pin with
rubber
retainer ring
on bottom of
lid is not in
place
Overheating is detected on
the cooking bowl
Bad power connection or
no power
Appliance electrical issue
Faulty temperature sensor
(cannot be detected)
Faulty temperature sensor
(short circuited)
Temperature is too high
because cooking bowl is
not in the pressure cooker
Temperature is too high
because there is no water
in cooking bowl
Faulty pressure sensor
20
SOLUTION
Check if pressure
release value is
turned to the seal
position
Install the rubber
gasket correctly
Check that red
interlock pin is
installed with the
rubber retainer ring
on the bottom of lid
Stop the program,
use the pressure
release valve to
reduce the internal
pressure and check
if the food at the
bottom of the
cooking bowl is burnt
Inspect the power
cord to ensure a
good connection,
check that the power
outlet is active
Contact the
consumer service
team
Contact the
consumer service
team