System Compatibility/Product Groups - Sperian Miller DuraHoist Manual De Instrucciones

System Compatibility
The Miller DuraHoist System is designed for use with Miller approved components. Substitution or replacement
with non-approved component combinations, sub-systems, or both, may affect or interfere with the safe function
of each other and endanger the compatibility within the system. This incompatibility may affect the reliability and
safety of the total system.
Product Groups
A comprehensive fall protection program must be viewed as a "total system" beginning with hazard identification
and ending with ongoing management review. Miller Fall Protection views its products as a "system within a
system". Three key components of the "Miller System" need to be in place and properly used to provide
maximum worker protection.
A
nchor Point/Anchorage Connector
The first component of the system is the anchor point/
anchorage connector. This point must be capable of
supporting 5000lbs (22kN) per worker or meet OSHA
1926.502 requirements for a safety factor of two, such
as an I-beam or other support structure. Anchorage
connectors, such as cross-arm straps and eyebolts,
are sometimes necessary to make compatible
connections between the connecting device and the
anchor point.
B
ody Wear
The second component is the personal protective
gear worn by workers while performing the job. Miller
Fall Protection manufactures full-body harnesses,
positioning belts and body belts for use in specific
work environments. Full-body harnesses are
engineered to aid in the arrest of a free fall and should
be worn in all situations where workers are exposed
to a potential free fall. The full-body harness must be
used in conjunction with shock-absorbing equipment
to keep fall forces to a minimum. It is imperative that
the harness be worn properly.
C
onnecting Devices
The final system component is the connecting device. The most important feature of the connecting device is the
built-in shock-absorber. Whether the connecting device is a shock-absorbing lanyard or self-retracting lifeline,
they are designed to dramatically reduce fall arresting forces. Rope, web or cable lifelines being used for fall
arrest MUST be used in conjunction with a shock-absorber (i.e. Miller SofStop pack.)
Used properly with each other, they form the "Miller System" and become a critically important part of the "total fall
protection system." Individually, none of these components will provide protection from a fall.
WARNING
•Visually check all buckles to assure
proper and secure connections before
each use. All straps must be connected
and adjusted to provide a snug fit.
•Fall protection connecting devices should
be attached to the back D-ring of a full
body harness.
Us e r I nst r uct i o ns - E ngl i sh
•Never attach non-locking snaps to a D-ring.
•Side, front, and chest D-rings should
be used for positioning only.
•Shoulder D-rings should be used for
retrieval only.
4
A
B
C