Technical Details - Siku CONTROL 1:32 Manual De Instrucciones

This box contains
a) battery charger and
b) power pack
to charge up the SIKUCONTROL Storage Battery.
The SIKUCONTROL Storage Battery is not included
in this box. It is supplied with the corresponding
vehicle.
Some information on how to use the Power Pack and
Charger.
Charging of the batteries must be carried out
by adults only.
Always protect rechargeable batteries from dirt and
moisture and clean the contacts regularly with a dry
cloth.
If the storage battery is not in use, always make sure
the switch is clicked to "OFF".
1. Click operating switch to "OFF" position.
2. Carefully remove the storage battery from the
model.
3. Slide the storage battery into the slot of the
harger.
4. Connect the power pack to the charger and then
connect the plug of the power pack to the mains.
Only use an original SIKUCONTROL power pack.
5. When the red control light shines, just switch the
charger to "ON". The green control light flashes
during the charging time (approx. 70 minutes). Should
the green control light flicker, the battery is com-
pletely empty. The light will start flashing properly as
soon as the charger has been running for a short
time.
The storage battery is fully charged as soon as the
green control light shines continuously.
6. Switch the operating switch of the storage battery
to "OFF" and disconnect the power pack from the
mains.
7. Withdraw the recharged battery from the charger
and insert it carefully into the model. The operating
14
switch is then on the left side when looking towards
the front of the tractor.
General Information: after approximately 500
charges the storage battery capacity will have slowly
dropped to about 80 % of the original capacity.
New batteries can easily be reordered with Part No.
6702.
Safety Instructions
Conformity to standards is guaranteed by the
manufacturer. Not suitable for children under 36
months, as small parts could be inhaled or
swallowed. Retain packaging for reference. The right
is reserved to amend and improve our products and
to alter colours without prior notice. Before use
please read the operating instructions carefully
and keep these for future reference. The battery
charger must be stored in a dry place and should
only be used under the supervision of an adult.
Rated voltage of charger: 230 Volt
Sieper GmbH
Schlittenbacher Str. 60, D-5851 1 Lüdenscheid
Deutschland / Germany /Allemagne
www.siku.de

Technical Details

Remote Control Module
Operating
method Infrared light waves
Dimensions 152x 125 x 50 mm
Weight 312 g
Power device 4 pieces 1,5 V Type AA*
*not enclosed
Charger
Entrance: 9 V 200 mAh
Dimensions: 72x 93 x 27 mm
Weight: 112 g
50 Hz.