Petsafe ppa00-11323 Manual De Instrucciones página 6

POWERING THE KEY
Open the collar key by twisting a coin between the two flanges (Fig. 19).
Remove battery holder (Fig. 20).
Place 2 x SR44, LR44 or D357 coin cells into the battery holder. The collar key
LED will flash 3 times indicating that the key is active (Fig. 21).
Replace battery holder into the clear base. Replace colored cap by clipping
the two halves of the key together, ensuring that the green pcb board is
visible through the clear base. (Fig.22).
The key will continue to flash at 2 minute intervals (Fig. 25).
FIG. 19 FIG. 20 FIG. 21
Battery should be replaced every 12 months or when the LED stops
flashing.
ATTACHING THE KEY
The key must be attached to the collar so that it hangs forwards (Fig. 24).
FIG. 24
6
POWER ADAPTER (OPTIONAL)
Plug adapter into a household electric socket (Fig. 25).
Place the jack plug into the socket at the side of the cat flap (Fig. 26).
FIG. 22 FIG. 23
PROGRAMMING YOUR CAT FLAP
After powering the cat flap and the collar
key, approach the flap with the key. The
red LED will stop flashing and the unit will
emit a high pitched beep. Your cat flap is
now programmed to recognize the collar
key (Fig. 27).
If you have more than one cat, you will
need to purchase collar keys of the same
color code.
The color codes available are:
Green, Yellow, Blue and Pink.
If your cat loses a collar key, you must
purchase a collar key of the same color or reprogram the cat flap with
another color coded key.
To reprogram the cat flap, please disconnect the batteries for
approximately one minute.
The latch will not relock until the cat key is out of range of the door.
FIG. 25 FIG. 26
FIG. 27