Install Glass Sweep And Weather Stripping - Petsafe Freedom PPA11-13098 Manual De Instrucciones

Puerta para mascotas en panel de patio
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

NOTE:
with glass on either the sliding glass door or the Patio Panel when drilling. If
needed, move the template over slightly and remark the screw holes.
4B
4C
Step

Install Glass Sweep and Weather Stripping

5
5A
installed on the front edge of the sliding glass door to form a seal between the
Freedom
Inspect location of screw marks to make sure they will not be in contact
Patio
Panel
Patio
Panel
Patio Panel and the sliding glass door.
www.petsafe.net
4B Drill four
7
/
" (2.5 mm) holes. DO NOT
64
drill completely through the other side of the
sliding glass door or Patio Panel.
4C Secure the latch and keeper with four
3
/
" fl at head sheet metal screws. DO NOT
4
OVERTIGHTEN.
Helpful Tip: If overtightening results and you
have stripped the connection, move the latch
slightly up or down and re-drill mounting
holes. Another option is to drill existing holes
to a larger size and install plastic anchors.
Plastic anchors can be purchased at any local
hardware or home improvement store.
Patio door shown here slightly open
Freedom
Install glass sweep here
Install weather stripping here
5A The glass sweep should be
installed on the back edge of the
sliding glass door to form a seal
between the sliding glass door
and the stationary glass door. The
weather stripping should be
Patio Panel Pet Door
9

Publicidad

Tabla de contenido
loading

Tabla de contenido