Publicidad
Idiomas disponibles
Idiomas disponibles
SET UP
Before setting up, it is important to make sure we have enough space to use the the
ETUBE SHOOTER AIR PLUS avoiding that the confetti (or any other consumable in
the etube) is directly pointed to people or objects, that may be too close and suffer
damage.
1. Put the machine in a stable and flat surface.
2. Connect the control to the control power input (4). You can use different control
systems (ie: 1 CHANNEL FX PUSHER, 1CHANNEL DMX SWITCH, etc). Once connected,
make a test of shooting without load by actioning the control. If the set up is correct,
the machine will shoot (if it is full of compressed air) and the indicating shooting led
(7) will light.
* If you need to action different machines ETUBE SHOOTER AIR PLUS at the same
time, connect the control power output (5) to the control power input (4) of the
other machine. This way the machines will all be actioned simultaneously.
3. If you want to work using the internal compressor of the ETUBE SHOOTER AIR PLUS
connect the compressor power input (2). The compressor will start to load with air.
Once it has finished, the indicating compressor led (6) will light.
* You can use the compressor power output (3) for the compressor of other ETUBE
SHOOTER AIR PLUS, connecting it to the compressor power input of the other
machine.
4. Adjust the inclination of the ETUBE adaptor by orientating to the desired angle.
Secure the position by tightening strongly the elbow nut (8).
FITTING OF THE ETUBE
1. Pull the fixing pins (10) in the ETUBE adaptor and turn them to its UNLOCK position,
so they remain upwards.
2. Insert the green side of the ETUBE (12) all the way into the adaptor (9).
3. Pull again the fixing pins (10) in the ETUBE adaptor (9) to its LOCK position hem back
60º, so they remain loose.
4. Turn the ETUBE (12) until the fixing pins lock themselves into the ETUBE (You must
hear a clicking noise confirming that the ETUBE is locked and secured).
5. Make sure the ETUBE is well fixed in the adaptor (9).
6. Tighten the safety pin (11).
ATTENTION: ETUBE is designed for one single use to guarentee its security.
If any time you wish to reload the charge, use only the aluminium tube provided.
3
INSTRUCTION MANUAL
Publicidad
