Descargar Imprimir esta página

Oh!FX Etube Shooter Air Plus Manual De Instrucciones página 4

Publicidad

Idiomas disponibles

Idiomas disponibles

OPERATION
1. Action the control to make the shot.
RELOAD
1. If you need to make several shots, you need to wait until the air compressor has
finished charging. The indicating led (6) be lit once the machine is ready to shoot
again.
2. To take out the used ETUBE (12), loosen the safety screw (11). Pull the fixing pins (10)
in the ETUBE adaptor and turn them 60º, so they remain upwards. Pull the empty
ETUBE, and throw it away to the recyclable wate-bin.
3. Fit a new ETUBE as per instructions above fitting of the ETUBE.
REMARKS
The ETUBE SHOOTER AIR PLUS allows an external compressor to be connected through
the additional air entry (15), in case you are using an external air compressor, you can
adjust the air pressure by regulating this compressor.
To control the machine, use a control pusher with flash position (not switch).
After each shot the machine will automatically recharge again the air tank with
compressed air. Wait until the machine is fully charged to make a new shot.
It is recommended to purge the compressor tank periodically to eliminate the water
that may have condensed inside it. To do that, make sure the tank is fully empty of air.
Loosen the purge valve (14) and let the water pour out. Put it back and tighten it once
finished.
GENERAL CAUTION FOR ETUBE SHOOTER AIR PLUS
The ETUBE SHOOTER AIR PLUS has been designed for the described effect. Any other
use, different from the written excludes Oh!FX (CONFETTISHOTS SLU) of liability and
warranty.
Set a safety perimeter of 3 meters around the machine in which nobody should access
at the moment of the shot.
Do not cover the ventilation grid of the ETUBE SHOOTER AIR PLUS.
Use only the consumables intended for that specific use, and duly certified.
Do not wet the machine. To clean it, use a damp cloth and dry it immediately.
In case of malfunction, stop using the machine. Do not attempt to disassemble the
machine and contact the distributor or manufacturer. Any manipulation may exclude
the warranty.
Only an adult and qualified person must operate the machine.
4
INSTRUCTION MANUAL

Publicidad

loading