Consumer Friendly Message Guide / Installation Trouble Shooting - Honeywell 8734001 Guía De Instalación Y Funcionamiento

CONSUMER FRIENDLY MESSAGE GUIDE
Unlock / Valid programming:
Lock:
Invalid Programming:
Low Voltage:
Super Low Voltage:
4 Incorrect code entry attempts:
Power on:
Chip Reset:
Lock Error:
Repeat operation after Lock Error:
NOTE: When battery is under low voltage, the lock will give the (Low Battery Warning: Beeps and
LED flashes red for 5 seconds). During this time your lock can still work. However once the voltage
is lower than 4.3V (called Super-Low Voltage), the operation of the locking and unlocking will not
work, user must replace batteries immediately.
INSTALLATION TROUBLE SHOOTING
Issue
Lock will not function
electronically
Latch is sticking.
1 long beep and LED illuminates green
2 short beeps and LED illuminates red
2 short beeps and LED flashes red twice
Beeps for 5 seconds
(7/9 times depends on operation is unlock/lock)
4 short beeps and LED flashes red four times
2 short beeps and LED illuminates red each attempt
1 long beep and 1 short beep and LED illuminates green
1 long beep and 1 short beep and LED illuminates green
(may occur several times or once in a while)
3 long beeps LED flashes red three times
2 short beeps three times LED flashes red six times
Solution
• Check that all batteries are fresh high quality
Alkaline Batteries
• Check for proper polarity (+ -) of all batteries
• Check that the Control Wire is attached to the
Interior Assembly
Installation screws of the lock may be too tight and have to
be loosened
• Remove Interior Assembly
• Slightly loosen the Mounting Plate Screws
• Lock and unlock using the Key
• Reattach Control Wire and Interior Assembly
Page 12