Adjusting Latch / Installing Latch - Honeywell 8734001 Guía De Instalación Y Funcionamiento

ADJUSTING LATCH
NOTE: Latch is shipped with the backset set at 2-3/8" (60mm)
Measure the backset (backset is distance between edge of the door and the
center of Lock).
TO CONVERT FROM 2-3/8" (60mm) BACKSET TO 2-3/4" (70mm) BACKSET
TO CONVERT FROM 2-3/4" (70mm) BACKSET TO 2-3/8" (60mm) BACKSET
NOTE: Curved part of Latch always faces
curved portion of Strike Plate
INSTALLING LATCH
5. INSTALLING THE LATCH (need phillips head screwdriver)
a. Make sure the face plate sits flush with the door. Do not force
the Latch into the mortise flush. Chisel out excess material if
necessary for a flush fit (Figure 5a).
b. Using two 3/4" (19mm). screws provided, screw the Latch into the
door with a hand held screwdriver. DO NOT OVER TIGHTEN
(Figure 5b).
2-3/8"(60mm )
2-3/4"(70mm)
PULL
PUSH
Figure 5a
Figure 5b
Page 3