Gemini GEM-P400 Manul De Operacion página 295

1
INSTALLING THE WATER LINE
CONNECT THE TUBING TO THE
8
REFRIGERATOR
NOTES:
• Before making the connection to the refrigerator, be
sure the refrigerator power cord is not plugged into
the wall outlet.
supply has sand or particles that could clog the screen
of the refrigerator's water valve. Install it in the water
line near the refrigerator. If using SmartConnect
Refrigerator Tubing kit, you will need an additional tube
Remove the access cover.
or screw cap from the water
valve (refrigerator connection)
and discard.
Place the compression nut and ferrule (sleeve) onto
the end of the tubing as shown. On SmartConnect
Refrigerator Tubing kit, the nuts are already
assembled to the tubing.
Insert the end of the tubing into the water valve
connection as far as possible. While holding the
For plastic tubing from a SmartConnect
Tubing kit, insert the molded end of the tubing into
is hand tight, then tighten one additional turn with a
wrench. Overtightening may cause leaks.
Fasten the tubing into the clamp provided to hold it
in a vertical position. You may need to pry open the
clamp.
1/4"
Copper
Tubing
Refrigerator Connection
Reattach the
access cover.
Installation Instructions
™
™
Refrigerator
™
Tubing
Clamp
1/4" Compression
Nut
Ferrule (sleeve)
SmartConnect
™
Tubing
11
(CONT.)
TURN THE WATER
9
ON AT THE
SHUTOFF VALVE
Tighten any connections
that leak.
INSTALLING THE REFRIGERATOR
10
Plug in the refrigerator.
Arrange the coil of tubing so
that it does not vibrate against
the back of the refrigerator
or against the wall. Push the
refrigerator back to the wall.
START THE ICE MAKER
11a
Set the ice maker power switch to the 0N position.
The ice maker will not begin to operate until it reaches
its operating temperature of 15°F (–9°C) or below.
It will then begin operation automatically.
Power
switch
AUTOFILL PITCHER
11b
See page 6, About the AutoFill Pitcher, for
from the system, and how to use the pitcher.
OFF
ON
Power switch model