Ecosource 230000 Manual De Instrucciones página 21

Eco-source AS CHARGING DEVICE
CONNECTION AT DC12V / USB 5V PLUGS
• Push ON/OFF buttton
• The LED is lighting.
12
• Check the available voltage of your device printed on its adaptator
( ex: Output=5V - 1 A)
• Connect your device to
), and charging is beginning...
CONNECTION AT 230V~50HZ PLUG
• Push ON/OFF buttton
• Press button.
06
• The LED is lighting to indicate 230V socket is ready to deliver energy.
13
• Check the available voltage of your device printed on its transformer ( ex: 80W).
Otherwise, on the transformer will be printed voltage (V) and current (A). With these
datas, use that method::
Power(W) = Voltage (V) x Current (A)
• All cumulate power must be lower than 200W*
• Connect your device to
Remarks:
If all cumulate powers are up to 200W*, 230V socket turns off. Unpluged all devices from
Eco-source and press reset button
Follow again all the upper steps after checked all connected power with fully charged
Eco-source.
200W*: Maximum providing power from Eco-source.
Be careful:
The 230V socket represents the same electric risk than a classical home socket.
230000-Manual-E.indd 21
01
or socket depending of your device voltage ( 5V or 12V
03 04
01
Ex: 5V x 0,5 A = 2,5W
, and charging is beginning...
05
.
08
EN
25/05/12 9:09:31