Troubleshooting - Chattanooga Group ColPaC Serie Instrucciones De Uso Y Funcionamiento

6. Close bottom drain valve and detach extension drain hose.
7. Plug unit back into the power source.
8. Clean and return ColPaCs to the chilling chamber.
9. Close chamber lid - chilling sequence begins again.
Dust and lint will accumulate on the condenser fins of the refrigeration unit. This must be removed periodically to
ensure highest efficiency. The condenser may be reached by removing the rear access panel. Always disconnect
power before cleaning the condenser.
Replacing Thermostat
1. Remove plate.
2. Remove bushing nut.
3. Remove packing in bushing nut.
4. Remove brass nut.
5. Remove rubber washer.
6. To reinstall, reverse procedure.
7. After installation, seal top of packing nut with silicone sealant.

Troubleshooting

PROBLEM
A. Unit plugged in but packs
not chilled.
B. Packs too cool.
C. Packs too warm
POSSIBLE CAUSE
1. Breaker for electric circuit off
2. Thermostat not functioning
3. Heating element burned out
4. Compressor failure
5. Refrigerant leak.
1.Thermostat set too low.
2. Thermostat failure.
1. Thermostat set too high
2. Thermostat failure
3. Power failure.
SUGGESTED SOLUTION
1. Turn breaker ON
2. Replace thermostat
3. Replace element
4. Contact factory
5. Contact factory.
1. Adjust thermostat.
2. Replace thermostat.
1. Adjust thermostat
2. Replace thermostat
3. Check electrical circuit.
6