emmeti EGWW-0712 Manual De Instalacion Y Uso página 45

3. USE OF FAN
3.4 Operation in ventilation mode
1 Press the MODE key to select the
The fan recirculates the ambient air without heating or cooling it.
2 The temperature can be selected but is not effect
3 Pressing the FAN button, select the fan speed:
AUTO
Auto* Low
4 Pressing the button to select the desired position of the baffle
Attention!
The signal is automatically sent to the fan; the display will briefly show
the symbol .
3.5 Operation in cooling mode "Cool"
 Press the MODE key to select the
- +
 Use the keys to set the desired room temperature (16÷30 °C).
The temperature can be set degree by degree.
 Use the FAN key to select the desired fan speed:
AUTO
Auto* Low
Cooling operation system
Te
- valve open
Ts+2 - fan running at set speed
(MAX if AUTO)
Ts+1
- valve closed
- the fan remains stopped for 5 minu-
Ts
tes, and then restarts at MIN speed
for 1 minute.
- Internal temperature display to
display fixed Ts-1
Ts-1
Attention!
The signal is automatically sent to the fan; the display will briefly show the
symbol .
Note:
Te: Environment temperature
Ts: Set temperature
Tw: Water temperature
operating mode.
Medium High
operating mode.
Medium High
- valve open
- fan running at set speed (MAX if
AUTO)
- valve open
- fan running at set speed (MED if
AUTO)
- valve open
- fan running at set speed (MIN if
AUTO)
- After 1 minute valve closed and the
fan is stopped
- the fan remains stopped for 5 minu-
tes, and then restarts at MIN speed
for 1 minute.
Tw
28
Keep the state
25
It's essential to include a motorized valve in the
water circuit in order to prevent the formation of
condensation.
The unit is a hydronic terminal and its operating
mode depends on the chiller or boiler.
GB GB
AUTO
AUTO
Fan stop
Fan start
45