Troubleshooting - RS Fast-Sort Manual Del Usuario

troubleShootinG

Symptom
1. Motor does not run.
2. There is a ticking sound.
3. Coins are not sorting into
tubes.
4. Counting is not correct
5. Coins are not counting
6. Display shows ERR in total
column
note: ERR1 : In case of wrong positioning between trays and front sensor or front sensor malfunction.
ERR2 : In case of wrong positioning between trays and back sensor or back sensor malfunction.
ERR3 : In case of wrong positioning between trays and sensors or sensors malfunction.
1. Check that the power cord is plugged in.
2. Check that the power switch is turned on.
3. Push the 'RUN/STOP' button again.
4. Check that the tube trays are positioned properly.
The ticking sound is normal. This is the anti-jam device.
Foreign objects and bent, damaged, or sticky coins may cause the machine to jam:
1. Tap machine gently on the side to loosen jam.
2. This unit is designed to resolve jams automatically, so wait about 15 seconds as the
Agitation Screw and Running Vessel rotate forwards and backwards.
3. If the machine is still not sorting, push RUN/STOP to stop sorting.
4. Loosen Hopper Lid Screw with coin.
5. Lift Hopper Lid and remove Inner Vessel, exposing Running Vessel.
6. Retrieve jammed item and replace Inner Vessel.
7. Screw Hopper Lid and push RUN/STOP to start sorting again.
If there is a ERR sign on each coin counting column, then the sensor is failed or
covered by something. Contact Royal Sovereign office.
If the counting sensor is broken, ERR will be seen on the display
Check that the tube trays are positioned properly
9
Check
FS-44P