Gigaset A39H Manual De Instrucciones página 24

Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base sta-
tion. The actual registration procedure will depend on the type of base station.
You must activate manual registration of the handset on both the handset and
the base station.
1. On the base station: 
press and hold the registration/paging key for min. 3 sec.
2. On the handset: 
¢
within 60 sec. of pressing the registration/paging key
¢
MENU Settings
Enter the system PIN of the base station (default is 0000)
flashes in the display.
Registering
Registration takes approx. 1 minute.
The following is displayed after succesful
registration:
If more than one handset is registered, the internal
number of the handset is shown in the upper left cor-
ner.
Initial charging and discharging of the
batteries
The correct charge level can only be displayed if the batteries are first fully charged
and discharged.
¤
18 h
¤
Please note
◆
After the first battery charge and discharge you may replace your handset
in the base station or charging cradle after every call.
◆
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
◆
The batteries may warm up during charging. This is not dangerous.
Warning
Please ensure that the handset is in the charging cradle if you are absent for a
long time (e.g. during holidays) or remove the batteries from the handset. Oth-
erwise the batteries could be damaged.
6
¢ ¢
OK Handset
Place the handset in the base station or charging cradle for 18
hours.
Then remove the handset from the base station or charging cra-
dle and do not replace it until the batteries are completely dis-
charged.
¢ ¢
OK Register HS
¢
¢
OK
.
OK
U
INT MENU