M-Audio BX5D2 Guia Del Usuario página 5

Front Panel
The front panel houses the Power LED, which
indicates whether the speakers (amplifier) power
is on or off.
1. Power LED
2. HF Driver (tweeter)
3. LF Driver (woofer)
Installation
For optimal performance of the BX5 D2, please read the following thoroughly and carefully prior
to installation.
Precautions
•
Handling: Please do not touch the speaker cones. The BX5 D2 set is packaged in the box
tightly, so your attention is required when taking the monitors out of the box. To avoid
possible damage to the speaker units, hold both sides of the monitor in order to pull it out
of the box. The speaker cones should not be touched in order to avoid damage even after
they are out of the box.
•
Correct Power Operation: Since the BX5 D2 contains its own amplifier, it must be
connected to a power outlet using the detachable AC cable provided. Before connecting
power, please make sure that the Voltage-Select Switch located on the speaker's rear
panel is set to the appropriate position, as described in the rear-panel features list
appearing earlier in this manual.
WARNING! Use of improper Voltage-Select Switch combinations may result in hazardous
conditions and/or damage to speaker components not covered by speaker warranty.
•
Connections:
balanced/unbalanced cable from the input of each BX5 D2 to your corresponding preamp,
computer or game console outputs. We recommend that you use high-quality balanced or
unbalanced cables for input connections. Also, ALWAYS turn off the power of the BX5 D2
and turn the volume of the BX5 D2 down to a minimum before making the necessary
connections.
You can connect
2
1
3
either an XLR
5
BX5
balanced cable or TRS