Installation On Wall - Skuttle Indoor Air Quality Products SK0-0055-001 Instrucciones Para La Instalación

Installation on Wall

1. Plan to position the humidistat about 5 ft. (1.52 m) above the
floor on an inside wall, away from discharge registers.
CAUTION: Avoid areas with extreme variation in relative
humidity (e.g., kitchens and bathrooms).
NOTE: Homeowners usually prefer the humidistat mounted
near the heating thermostat.
2. To convert the humidistat from a duct-mount to a wall
configuration:
• Pull the indicator knob off the humidistat control shaft.
• Remove the mounting screws and detach the mounting
plate.
• Rotate the control 180º (half way).
Reattach the mounting plate. (See Figure 2 on page 4.)
•
3. Drill a 3/8 in. (0.95 cm) hole in the indention on the mounting
plate.
4. Place the mounting plate horizontally on the wall where the
humidistat is to be installed. Make sure it is level. Mark the wall
through the hole in the mounting plate. Remove the plate and
drill a 3/8 in. (0.95 cm) hole in the wall.
5. Run low voltage wire to the designated humidistat location and
pull approximately 6 in. (15.24 cm) of wire through the hole.
6. Plug the hole with nonflammable insulation to prevent drafts
from affecting the humidistat operation.
7. Place the mounting plate over the wire and pull the wire through
the hole previously drilled in the plate.
8. Use four 1 in. (2.54 cm) screws to secure the mounting plate to
the wall.
9. Connect the wires to the terminals on the humidistat control.
10. Use one 3/8 in. (0.95 cm) screw to secure the humidistat cover.
11. Remove the backing from the cover label and attach it to the
recessed area on the humidistat.
12. Push the indicator knob onto the humidistat control shaft.
3