Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
ENGLISH
1. Remove the two screws on the battery cover with the Phillips #1 drive
screwdriver.
2. Install three AAA batteries as per the polarity icons on the battery compartment.
3. Replace the battery cover and screws.
Warning!
- Substitution of Components May Impair Intrinsic Safety.
- Use only Durcell MN2400 LR03, Energizer E92 LR03, Philips, PN LR 03 (Powerlife) or
Panasonic, PN LR03 (Xtreme Power) AAA size alkaline Batteries.
- To reduce the risk of explosion, do not mix old batteries with new batteries, or mix batteries
from different manufacturers.
- To reduce the risk of explosion, batteries must only be changed in an area known to be non-
hazardous.
ATEX Zone
Ambient temperature Ta
Light source
Power supply
Protection rating
Weight
Length
Ex designation
Batteries incluided
4
BATTERY INSTALLATION
CARACTERÍSTICAS TÉCNICAS
0, 1, 2 GAS / 20, 21, 22 DUST
-20ºC - +50ºC
1W Led
3 x AAA batteries (type tested)
IP65
120g
71mm
I M1 Ex ia I Ma, II 1 G Ex ia IIC T4 Ga, II 1D Ex ia IIIC T65ºC Da IP65
Yes
Publicidad
Tabla de contenido
