6.2 Connection to the Internet
1.
Follow the instructions step-by-step until the last step.
2.
After reaching the last step of the procedure on the Web browser, if the proce-
dure was successful, the WEB LED will start emitting rapid green flashes.
3.
Detach the LAN cable from the PC and reconnect it to the router.
4.
The WEB LED will turn steady green. The procedure will now be complete.
Note:
in the event of failure (the WEB LED is lit red), repeat the procedure pre-
viously described in Paragraphs 6.1 or 6.2.
NOTE 2: if the procedure fails (WEB LED steady red), the LAN parameters can be reset
68
through the prolonged pressing of the configuration button for a time between 5 and
15 seconds. The Gateway will restart and the connection procedure can be rerun from
step 1 of Paragraph 6.1.