Connection Diagram; Quick Setup - Alto Professional RMX1508DFX Manual De Inicio Rápido

BOX CONTENTS
RMX1508DFX
Power cable
Quickstart Guide
Safety Instructions & Warranty Information booklet

CONNECTION DIAGRAM

QUICK SETUP

Follow the procedure below to have a signal processed for each channel:
1. Set all channel levels to zero, set pan to the middle, set output to zero, and set EQ's flat.
2. Connect your mic and then apply phantom power if your mic requires this.
3. Set the Master output level to no more than 75% and the Monitor output to no more than 50%.
4. Bring up the channel level.
5. Repeat steps 1 and 2 to setup more channels.
Notes:
Microphones, monitors, amplifier, speakers, cables, etc. are not included.
To reduce electrical hum at high gain settings, keep the mixer's power supply away from your guitar cable and
the mixer's channel inputs.
To use an external effects rack unit, compressor, etc., use a Y-cable (1/4" stereo to two 1/4" mono) to connect
the AUX OUT to the left and right inputs your external device. Connect the outputs of your external device to
the mixers Stereo Return.
2