General Comments; Warnings; Design Standard; Technical Characteristics - Aqua Isipool Rx L3 Manual De Instalacion Y Uso

1.0 GENERAL COMMENTS

1.1 Warnings

The aim of the AQUA S.p.A. pump manual is to provide you with all the necessary information for a
proper installation and maintenance in order to give you optimum results whilst in operation.
For this reason it is really important reading with attention the instructions given below since they furnish
all the indications necessary for the sureness of the installation, use and maintenance
This manual has to be preserved with care to be consulted in whatever occasion.
At the moment of the receipt you have to check the integrity of the pump and of all its components, in
case of anomalies consult skilled staff before making interventions.
Before the installation of the pump check that all the data on the pump's label correspond
to those of the electrical plant.
Do not operate with bare/naked hands or feet
Do not leave the equipment exposed to the action of the atmospheric agents.
The equipment has to be operated from skilled person.
In case of improper functioning of the pump switch off and contact our technical assistance
for any necessary repairs.
For a correct functioning it is necessary to use original spare parts and original accessories.
AQUA S.p.A. declines whatever responsibility in reference with break down due to
tampering or the use of not original spare parts and accessories.
The electrical plant has to be in conformity with the rules of the country where it is
realised.
The room temperature of utilisation can't over take 45° C

1.2 Design standard

Our pumps are built according to the actual general directives endowed with CE mark in conformity
with the following European directives:
N° 89/336/CEE regarding "electromagnetic compatibility"
N° 73/23/CEE regarding "low voltages", as also the subsequent modification N°93/68/CEE
and according to the procedures preview from our quality manual that follows the
ISO 14001:1996 and ISO 9001:2000 directives.
Granted this we think that in order to obtain an high trustworthiness and a lasting functioning of the pump
it is necessary to follow with attention our manual particularly in reference with the maintenance.
AQUA S.p.A. declines all responsibility in reference with whatever
intervention on the equipment from not skilled personnel.

2.0 TECHNICAL CHARACTERISTICS

2.1 General rules

Install the pump:
On an horizontal reinforcement (ex: stoking tank) so that
the pump head stays always in vertical position +/-15°.
far from an hot source in dry places at maximum temperature of 45°C and minimum 0°C.
In a ventilated place and easily accessible by an operator for periodical maintenance.
At a suitable height above the chemical up to a maximum height of 1.5 meters. If for exigency
of the plant it's necessary to install the pump under the level of the chemical, you need to use an injection
valve or an anti siphon valve.
Do not install the pump over the tank in presence of liquids that emanate fumes unless it
is hermetically closed.

2.2 Electrical characteristics

Power supply: 230 VAC 50/60 HZ

2.3 Electric connection

Before installation ensure that the supply is adequately earthed and is fitted with a suitably
sensitive circuit breaker . Connect the pump to the power supply respecting the values
you can see on the identify label of the pump.
12/05/2010 13